pvitoria

Hi all, have been around my 320 CDI for some some days to fix a P0101 error from the right side MAF sensor. Plug in Xentry made all tests and tried other MAF sensors i have all are fine on the left side but not on the right side. Car enters limp mode constantly so after doing all this and also talking to a friend he agreed that a possible problem might be in the harness. Is the wiring fitted on the main engine harness or is there a way to replace the MAF harness only? Thanks in advance

konigstiger

Before tracing back harness see if attached bulletin/suggestions offers any additional insight.

pvitoria

Tks Konigstiger only thing i didn t do was to reset HFM will try that other checks did them all. The Y intake is new has around 3k km

pvitoria

Did the HFM reset and all the same car rides in limp mode and git a P0192 rail sensor error too

pvitoria

Fuel rail sensor was the problem € 250 for the sensor