Finally got a PC, now check this out...
Thread Starter
Senior Member
Joined: Nov 2001
Posts: 436
Likes: 0
From: So Cal
Finally got a PC, now check this out...
Check the pic below to see the swirls that I'm up against.
I posted over at the Autopia forums and got some good advice, I want to see what you guys think.
This is my plan:
1) Wash
2) Clay
3) Use 3M FI-II
4) Use Meguairs #9 swirl remover
5) Either P21S gloss enhancing paint cleanser or 3M IHG????
6) S100 Wax.
Main thing that im trying to do is remove swirls with the FI-II then cover it up with the P21S GEPC or IHG.
Sound good?
I posted over at the Autopia forums and got some good advice, I want to see what you guys think.
This is my plan:
1) Wash
2) Clay
3) Use 3M FI-II
4) Use Meguairs #9 swirl remover
5) Either P21S gloss enhancing paint cleanser or 3M IHG????
6) S100 Wax.
Main thing that im trying to do is remove swirls with the FI-II then cover it up with the P21S GEPC or IHG.
Sound good?
MBWorld Fanatic!
Joined: Jun 2002
Posts: 1,343
Likes: 0
Your plan sounds fine. I would use GEPC over IHG. Very easy to use and great shine. Ali's right on. You'll have to work FI2 in quite a bit to make sure it is fully breaking down. As long as you are patient, the results will be wonderful. Post pics! 
Thread Starter
Senior Member
Joined: Nov 2001
Posts: 436
Likes: 0
From: So Cal
Originally posted by AlBoston
P21S GEPC is better. Beware, 3M FI2 is difficult to use.
P21S GEPC is better. Beware, 3M FI2 is difficult to use.
I'll be sure to post pics when i'm finished, but i'm going to do it in 2 weeks or so.
