W212 E350 BLUETEC throw code P229F right after refill Blue DEF
Thread Starter
Newbie
Joined: Apr 2016
Posts: 3
Likes: 0
W212 E350 BLUETEC
W212 E350 BLUETEC throw code P229F right after refill Blue DEF
Hello,
I've been driven this diesel powered w212 worry-free for 1.5 year. It was not until recently, the 'adblue refill reminder' appeared on dashboard, I did some research and purchased 2 jugs of 2.5 gallon Peak BlueDEF (manufactured in March, 2016) and put into my car. After ~100 miles driving, the check engine light pops out today when I drive from home on highway. Had the car checked at a local Autozone, and the code I have is P229F NOx Sensor Circuit Range/Performance (B1S2).
I'm curious that was this code caused by the inferior DEF since it was not the dealer recommended Adblue, even though I saw a lot of people are using this product for their diesel Mercedes, Bmw, etc.
It seems the code is pointing to the NOx sensor, it should be fixed by just replacing the sensor, but I need to make sure the DEF I have in tank won't cause the sensor issue another time.
Please advice and comment,
Thanks in advance!
Vincent
I've been driven this diesel powered w212 worry-free for 1.5 year. It was not until recently, the 'adblue refill reminder' appeared on dashboard, I did some research and purchased 2 jugs of 2.5 gallon Peak BlueDEF (manufactured in March, 2016) and put into my car. After ~100 miles driving, the check engine light pops out today when I drive from home on highway. Had the car checked at a local Autozone, and the code I have is P229F NOx Sensor Circuit Range/Performance (B1S2).
I'm curious that was this code caused by the inferior DEF since it was not the dealer recommended Adblue, even though I saw a lot of people are using this product for their diesel Mercedes, Bmw, etc.
It seems the code is pointing to the NOx sensor, it should be fixed by just replacing the sensor, but I need to make sure the DEF I have in tank won't cause the sensor issue another time.
Please advice and comment,
Thanks in advance!
Vincent
Member
Joined: Dec 2015
Posts: 110
Likes: 10
From: Northen California
2012 e350 bluetec
I've been using Peak DEF for four years with no problems. It carries the correct ISO approval according to MB specs. It's probably either something else gone wrong or maybe related to the low warning light having gone on. Perhaps it will turn off after a certain number of engine restarts. Some OBDii errors reset when a problem has been corrected and it no longer senses the issue.
Member
Joined: Dec 2015
Posts: 110
Likes: 10
From: Northen California
2012 e350 bluetec
Here's another thing to think about. If you can't find a listing for a P229F OBDII code try substituting '15' for the 'F'. The hexadecimal code 'F' equates to a decimal '15'. Maybe that will help track down a more specific fault.
