Diesel Forum Forum for Diesel engine vehicle related discussion
Sponsored by:
Sponsored by:

2012 ML 350 BlueTec- Limp mode, no check engine light, no codes

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 03-28-2024, 02:38 PM
  #1  
Newbie
Thread Starter
 
Starlifter's Avatar
 
Join Date: May 2012
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
2012 ml350 bluetec
2012 ML 350 BlueTec- Limp mode, no check engine light, no codes

Upon entering a highway or accelerating from traffic, kicks into limp mode no CEl/no codes, resets when vehicle is shut off and turned on again. Then runs fine at highway speeds. Anyone experience this issue
Old 03-28-2024, 07:27 PM
  #2  
MBWorld Fanatic!
 
rapidoxidation's Avatar
 
Join Date: Jan 2016
Location: In the Shadow of the Tetons
Posts: 2,316
Received 678 Likes on 491 Posts
2013 ML350 Bluetec
If it went into limp mode, there's a code stored. A decent scanner will reveal what's up.
Old 03-28-2024, 09:56 PM
  #3  
MBWorld Fanatic!
 
tjts1's Avatar
 
Join Date: May 2017
Posts: 2,211
Received 410 Likes on 341 Posts
C320
Likely clogged DPF.
Old 03-29-2024, 02:09 AM
  #4  
MBWorld Fanatic!
 
kajtek1's Avatar
 
Join Date: Jan 2009
Location: V E G A S
Posts: 9,093
Received 1,736 Likes on 1,384 Posts
1922 Ford Model T / no OBD
SAFE mode during acceleration is typical for intercooler leaks. Look for oily stains on the system.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 


You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: 2012 ML 350 BlueTec- Limp mode, no check engine light, no codes



All times are GMT -4. The time now is 02:39 AM.