Hello Forum Friends;
Attached , I have a pic of the code reader I have for m119 ; Also is a pic of my actual 38 pin diagnostic connector/module on my 1992 400e.....
My issue is that the plastic surrounding pin 3 is deteriorated fell apart ;so wire from code reader does NOT insert into the pin(3)...
is there another pin that supplies power for getting codes??
Any other suggestions/ advise on reading codes from module?? (the code reader I have was highly recommended by member of this forum who used same kind with Great results... THANKS All Chance
Attached , I have a pic of the code reader I have for m119 ; Also is a pic of my actual 38 pin diagnostic connector/module on my 1992 400e.....
My issue is that the plastic surrounding pin 3 is deteriorated fell apart ;so wire from code reader does NOT insert into the pin(3)...
is there another pin that supplies power for getting codes??
Any other suggestions/ advise on reading codes from module?? (the code reader I have was highly recommended by member of this forum who used same kind with Great results... THANKS All Chance

