Stuck in 3rd gear after conductor plate change
10-16-2022, 07:56 PM
#1
Junior Member
Thread Starter
Join Date: May 2021
Location: South Carolina
Posts: 22
Likes: 0
Received 1 Like
on
1 Post
2004 S55 AMG 1998 E430
Stuck in 3rd gear after conductor plate change
Hey all,
I just got done replacing the conductor plate and plug in my 2002 E430, and after buttoning it back up and refilling the fluid I知 having the same issue. The car shifted through P-D very smoothly on the first startup, and shifted fine for about 30 seconds until it immediately got stuck in 3rd (or 4th) again and will now shift roughly into D and R. It has a new TCU as well, I知 getting no transmission codes with my Foxwell scanner through the 38-pin, and I知 honestly at a loss on what to do now, any ideas?
I just got done replacing the conductor plate and plug in my 2002 E430, and after buttoning it back up and refilling the fluid I知 having the same issue. The car shifted through P-D very smoothly on the first startup, and shifted fine for about 30 seconds until it immediately got stuck in 3rd (or 4th) again and will now shift roughly into D and R. It has a new TCU as well, I知 getting no transmission codes with my Foxwell scanner through the 38-pin, and I知 honestly at a loss on what to do now, any ideas?
10-17-2022, 04:07 PM
#2
Out Of Control!!
make sure that all the parts were new MB parts and applicable to your VIN------if there are any no answers they you just wasted loads of time and money and dump the hs fox stuff and get a factory set and do over or sell the car
10-17-2022, 04:29 PM
#3
Junior Member
Thread Starter
Join Date: May 2021
Location: South Carolina
Posts: 22
Likes: 0
Received 1 Like
on
1 Post
2004 S55 AMG 1998 E430
I知 not really understanding most of your comment, but all the parts I used were Mercedes parts or Lemforder which is very reliable. What is HS Fox?
