Program retrofitted Comand Navi to use speedo display?
#1
Member
Thread Starter
Program retrofitted Comand Navi to use speedo display?
Anyone good at Star programming?
As title says, I have retrofitted a Comand NTG 2.5 to my 2003 W211. Everything is working as it should, but i also want the speedo display to show navi guidance.
I have the Star programming tools, but i am not very familiar with using it yet.
Anyone here know how to do this? And maybe could give me some guidance? Or maybe there is a writeup somewhere for this, or for Star programming in general?
Appreciate any help :=) Thanks.
As title says, I have retrofitted a Comand NTG 2.5 to my 2003 W211. Everything is working as it should, but i also want the speedo display to show navi guidance.
I have the Star programming tools, but i am not very familiar with using it yet.
Anyone here know how to do this? And maybe could give me some guidance? Or maybe there is a writeup somewhere for this, or for Star programming in general?
Appreciate any help :=) Thanks.
#2
Super Moderator
Should be under the IC and maybe the central gateway.
The best way to learn star is to just play with it but be careful with what you change and write down everything you change and where it was. I keep a running word document of exactly where the setting was and what it was set to and what I put it to. This saved me big time years ago with my w203 when I enabled something and then I locked up star. Went to start car and had tons of error lights pop up apparently I had set some setting that did some very bad things lol
The best way to learn star is to just play with it but be careful with what you change and write down everything you change and where it was. I keep a running word document of exactly where the setting was and what it was set to and what I put it to. This saved me big time years ago with my w203 when I enabled something and then I locked up star. Went to start car and had tons of error lights pop up apparently I had set some setting that did some very bad things lol