E500 4matic PDC display problem
Thread Starter
Newbie
Joined: Aug 2015
Posts: 4
Likes: 1
From: Bulgaria
W211 04' E500 4matic
E500 4matic PDC display problem
Hello all,
I've just joined the forum as recently I got myself a 2004 E500 4matic W211.
However, I've came to a problem now. Everything was fine until I went through one big hole and my PDC stared acting strange. It mostly is not working and when I go through bad road/holes it starts and goes off again. I got the car inspected and the error was that there is not enough voltage reaching the PDC display. I think that the faulty one is the front one but my question is do you know how do I disable these?
Thanks in advance.
I've just joined the forum as recently I got myself a 2004 E500 4matic W211.
However, I've came to a problem now. Everything was fine until I went through one big hole and my PDC stared acting strange. It mostly is not working and when I go through bad road/holes it starts and goes off again. I got the car inspected and the error was that there is not enough voltage reaching the PDC display. I think that the faulty one is the front one but my question is do you know how do I disable these?
Thanks in advance.
Last edited by byKolev; Aug 30, 2015 at 02:57 PM.
