W212 Throttle Pedal Sensor Pinout
#1
Junior Member
Thread Starter
W212 Throttle Pedal Sensor Pinout
I'm utilising a W212 throttle pedal on my M113K 560SEC project and was wondering if anyone has a wiring diagram/pinout for it so I can get the wiring correct to my Haltech ECU.
#2
MBWorld Fanatic!
Where the hell did you find a 113k?
Get WIS/ASRA on ebay. Diagrams galore. I'd pull it up from mine for you but I'm too lazy to fire up the vbox.
Get WIS/ASRA on ebay. Diagrams galore. I'd pull it up from mine for you but I'm too lazy to fire up the vbox.
#3
Junior Member
Thread Starter
For future reference if anyone needs the info, the pedal is manufactured by Hella and is found on many Mercedes vehicles from around 2007 to 2018. It has a flat 6 pin connector. After a bit or mucking around with a bench top voltage supply and multimeter I determined the pin out as follows:
Pin 1: +5V
Pin 2: APP1 signal
Pin 3: Ground
Pin 4: Ground
Pin 5: Not used
Pin 6: APP2 signal
Pin 1: +5V
Pin 2: APP1 signal
Pin 3: Ground
Pin 4: Ground
Pin 5: Not used
Pin 6: APP2 signal
The following 2 users liked this post by Brento:
pierrejoliat (10-28-2022),
S. Madman (10-26-2022)
The following users liked this post:
pierrejoliat (10-28-2022)