Mark this thread as Unsold
Updated C3P Pulley for sale
Thread Starter
MBWorld Fanatic!
Joined: Aug 2006
Posts: 1,717
Likes: 0
From: Keesler AFB, Gulfport, MS
C32 AMG
Updated C3P Pulley for sale
I have had this C3P pulley installed for about 2 months now and have less than 1k miles on it. My idler pulley just bit the dust (NOT due to the pulley) as is so common, and rather than replace the idler with another stock unit I decided to upgrade the entire setup and go with a 185mm LET kit with a different idler pulley.
The pulley is a 2nd Gen updated version from the initial pulleys they released which chewed up belts. For those not familiar with this pulley, its good for a dyno proven 25/30hp at the wheels and uses all stock parts. I will post pictures after work, but wanted to get this posted before I forgot.
C3P and LET are selling these pulleys new for $650 HERE and HERE.
$450obo includes the pulley and an extra set of brand new bearings.
The pulley is a 2nd Gen updated version from the initial pulleys they released which chewed up belts. For those not familiar with this pulley, its good for a dyno proven 25/30hp at the wheels and uses all stock parts. I will post pictures after work, but wanted to get this posted before I forgot.
C3P and LET are selling these pulleys new for $650 HERE and HERE.
$450obo includes the pulley and an extra set of brand new bearings.
Thread Starter
MBWorld Fanatic!
Joined: Aug 2006
Posts: 1,717
Likes: 0
From: Keesler AFB, Gulfport, MS
C32 AMG
All PMs replied too. I will post here so I don't have to keep reminding people in PMs; if you have not upgraded any of your cooling (ie pump and/or heat exchanger) I would recommend getting your cooling in line before doing any other mods.
Not to say you can't run the C3P pulley with stock cooling, because you can. I just want all the new people to the forum that have been PMing me to be aware.
Not to say you can't run the C3P pulley with stock cooling, because you can. I just want all the new people to the forum that have been PMing me to be aware.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
