Mark this thread as Unsold
FS: Aquamist HFS-3 Methanol Injection Kit
Thread Starter
MBWorld Fanatic!
Joined: Jul 2008
Posts: 2,172
Likes: 3
From: Philly
997TT, C192 GT63, W464 G550, MS Plaid
FS: Aquamist HFS-3 Methanol Injection Kit
Up for sale is my Aquamist HFS-3 progressive Methanol injection kit. It has served me well for close to 11 months now and about 3500 miles. I have switched my 996tt over to E85 and no longer use Methanol injection.
When I had it installed it allowed me to make 692whp on 93 octane with Meth. I used to run 100% VP M1 Methanol with this kit.
I will also throw in a 1 gallon plastic tank with the level sensor pre-installed and the pump fitting pre-installed as well.
It will come with original wiring harnesses etc. I have the RED flow gauge.
I had this wired up to have a failsafe so if i ran out meth, nozzles got clocked or simply the meth system was turned off my car would run 1.0 bar of boost. With Meth flowing iwas running 1.55 bar of boost
Here is a picture of the pump installed in my car...
When I had it installed it allowed me to make 692whp on 93 octane with Meth. I used to run 100% VP M1 Methanol with this kit.
I will also throw in a 1 gallon plastic tank with the level sensor pre-installed and the pump fitting pre-installed as well.
It will come with original wiring harnesses etc. I have the RED flow gauge.
I had this wired up to have a failsafe so if i ran out meth, nozzles got clocked or simply the meth system was turned off my car would run 1.0 bar of boost. With Meth flowing iwas running 1.55 bar of boost
Here is a picture of the pump installed in my car...
