fieldcromer

I’m installing a led star to my 2004 G500 I need help on finding the hole in the fire wall to run my switch into the cab I do not want to drill and I can’t find the existing hole any suggestions?

almostordinary

Would't you want to tap into maybe the foglight circuit (if it accepts LEDs, which it may not then you will need to install ohm load resistors).

Cleaner install and not drilling into the firewall for a simple switch.

Check this vid out if you go that route: (Warning, very cheesy opening)

aerG500

One of the firewall pass-thru points is at the very corner upper right side. There’s a round black rubber sleeve covering the bundle of wires at the entry point, if you slowly pull the lip out of the firewall, you’ll gain access. I circled the area in yellow for you, Good luck

Floobydust

If it were me, I would tap into the parking light circuit so that the star is illuminated when the lights are on. This circuit is easily accessible on a 2004 behind either the left or right front headlights. The extra load from the LED lighted star will not bother the parking light circuit on a 2004. No need for kludgey resistors or to penetrate the firewall.

TazRider

I tied mine to the LED lights on the headlight covers. I was scared I would kill the LEDs so I bought two set. Now I'm stuck with a spare. Set Hahahshshshs

bnZE430/1999

that looks nice. Where did you get it from? Wanna sell me your spare?

TazRider

​​​​​​
Ordered mine from this shop in California. Can't remember the name. I'll sell my spares since I haven't got them painted yet.