Car not level, Airmatic working fine.
Thread Starter
Out Of Control!!
Joined: Aug 2010
Posts: 12,516
Likes: 628
From: Charlotte NC area
2019 WS222 S450 4-Matic / 2007 W211 E350 4Matic (Sold) / 2008 X164 GL320 CDI
Car not level, Airmatic working fine.
The car is just a little off level.
No errors showing, car raises and lowers fine.
Car does not lose air when sitting.
How do you find out which corner sensor is bad.
Is there a calibration process?
No errors showing, car raises and lowers fine.
Car does not lose air when sitting.
How do you find out which corner sensor is bad.
Is there a calibration process?
Thread Starter
Out Of Control!!
Joined: Aug 2010
Posts: 12,516
Likes: 628
From: Charlotte NC area
2019 WS222 S450 4-Matic / 2007 W211 E350 4Matic (Sold) / 2008 X164 GL320 CDI
Do you know any one in the Charlotte NC area with a Star system?
MBWorld Fanatic!
Joined: May 2015
Posts: 1,932
Likes: 291
From: Allentown, PA
'08 GL 320 CDI
Before you replace anything, pop each plastic arm off and clean the cup and the ball. Make sure the sensor arm moves freely. Then put the plastic arm back on with some grease. One of the black, plastic arms may just be getting hung up a bit from rust/corrosion/debris in the ball-socket joint.
Newbie
Joined: Sep 2020
Posts: 2
Likes: 0
GL450
As Dennis said, check those little plastic arms. I found the ball coupler where they mount was seized and because those arms are weak rubber they would just bend and not set the sensor to the correct position. I popped them off, cleaned, and lubricated them with some grease and the rig sits level now.
Thread Starter
Out Of Control!!
Joined: Aug 2010
Posts: 12,516
Likes: 628
From: Charlotte NC area
2019 WS222 S450 4-Matic / 2007 W211 E350 4Matic (Sold) / 2008 X164 GL320 CDI
As Dennis said, check those little plastic arms. I found the ball coupler where they mount was seized and because those arms are weak rubber they would just bend and not set the sensor to the correct position. I popped them off, cleaned, and lubricated them with some grease and the rig sits level now.
On my todo list.
