Garik

Hello Everybody, after reading this forum for last three months, finally i bought my ML. Of course the fun is not over, but just the beggining. Comming from world of sport cars, this thing is sort of high in the air, so now I am looking towards putting it down(lowering the ML). By going to a few web sited I found that they sell four springs as replacement for lowering, but when I checked my ML I found that there is no springs in the front.
So here is the question: How can i lower this "Brick."
Thank you everybody!

jswedberg

The rears will need springs, the front torsion rods can be adjusted without buying anything else.

Garik

Thank you for information, following question will be is it something i can do my self, or it has to be done in the shop only. (if anyone done it)

Thank you again!

azn_dgn

u can do it ur self if u know wut too do,
but personally i'd trust a professional with ur car. . .

Garik

well found the solution, Local shop will lower front end, replace rear springs with H+R, realign the wheels for 375$
I think i will go with them...

anyone else if interested in Seattle area here is the link
www.handrsprings.com They are located in Bellevue