ML Navi Voice
12-05-2007, 08:20 PM
#1
Newbie
Thread Starter
Join Date: Mar 2007
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
ML Navi Voice
I just installed a navi drive on the MCS. Everthing seems to work as far as mapping goes but I,m getting no voice instructions, just a pause and a bit of static.
Any ideas.
Thanks
Any ideas.
Thanks
12-06-2007, 10:07 AM
#3
Senior Member
Join Date: Jul 2004
Location: New England
Posts: 260
Likes: 0
Received 2 Likes
on
2 Posts
1990 190E 2.6, ... 1998 ML320, 2005 ML500SE
Try this. push the NAV VOICE button, the one on the bottom, to repeat the last nav voice prompt and just after you hit the button rotate the volume control to increase the volume. The nav volume is independent of the radio volume and can only be adjusted while the nav is currently speaking. You must be in nav mode and currently navigation to somewhere. You will know when the Nav Voice is speeking when the radio volume is muted.
Mike
Mike
12-06-2007, 11:09 AM
#4
MBWorld Fanatic!
Join Date: Nov 2001
Location: Philadelphia area
Posts: 4,260
Likes: 0
Received 4 Likes
on
3 Posts
2010 ML550, 2010 E350 4M, 1966 Corvette Convt C2
Try this. push the NAV VOICE button, the one on the bottom, to repeat the last nav voice prompt and just after you hit the button rotate the volume control to increase the volume. The nav volume is independent of the radio volume and can only be adjusted while the nav is currently speaking. You must be in nav mode and currently navigation to somewhere. You will know when the Nav Voice is speeking when the radio volume is muted.
Mike
Mike
12-21-2007, 02:53 PM
#6
Junior Member
Join Date: Mar 2007
Location: NJ
Posts: 25
Received 0 Likes
on
0 Posts
'11 GL350, '03 Audi A4 Avant 1.8T
Make sure in the settings, voice instruction is on...
