Lowering Kit?
03-10-2009 | 08:41 PM
#1
Thread Starter
Member
Joined: Sep 2007
Posts: 116
Likes: 0
From: NJ
2004 ML 500
Lowering Kit?
Well, the title pretty much says it all. What would be the best way to go about lowering an ml? I think it'd really give a sick look if it were running 2" lower or so. Thanks guys
03-15-2009 | 03:55 AM
#2
Out Of Control!!
Joined: Dec 2004
Posts: 14,212
Likes: 7
From: Boston, MA
00 MB ML55, 91 Toyota Supra Turbo(sold), 06 E500(gone), 03 BMW M3
hmmm dont do it... my car is low... Looks fantastic, rides terribly... I used H&R lowering springs... and lowered the front via the torsion bars... The back rides fine but the front is so loose that there isnt anything to help the front... I bottom out on EVERYTHING
03-15-2009 | 09:22 AM
#3
Thread Starter
Member
Joined: Sep 2007
Posts: 116
Likes: 0
From: NJ
2004 ML 500
haha alright thanks. My car was actually riding too high up front I just found out. If you were to look at it it was sitting way too high, the mechs apparently set the torsion bar too high. theyre gonna lower it back down, so maybe that'll help the look a bit
