Driver's inside pull handle
Thread Starter
Newbie
Joined: Aug 2013
Posts: 12
Likes: 0
From: Ky
1999 ML320
Driver's inside pull handle
My driver's inside pull handle broke at the top screw and I need to replace it. If anybody out there has a dark grey handle with wood trim (I don't need the wood trim but..) or know where I can get one it would be much appreciated. Thanks
Last edited by luvmyskyrl; May 2, 2014 at 03:22 PM.
Junior Member
Joined: Oct 2013
Posts: 70
Likes: 0
From: Mn
2006 ML 350 sold, 2014 Bluetec "Rudy"
I am surprised by lack of response on this thread. I have been around 4 different 163 MLs and on all in have had to fix the pull. All by very crudely using JB Weld. All were broke where it attaches through the door panel. On one I even used a wooden dowel on backside for screw to go in to. It has not happened on the one just purchased yet. However I don't see them offered on ebay or any repos being made. I may have just found a way to make some money. Hard to believe 4 out of 5 I have been around have had the problem but no one talks about it on forums.
Tell us about how you fixed yours, I wish I had taken pictures of past projects.
Tell us about how you fixed yours, I wish I had taken pictures of past projects.
Thread Starter
Newbie
Joined: Aug 2013
Posts: 12
Likes: 0
From: Ky
1999 ML320
I couldn't find a handle anywhere so I ordered a new one without the wood trim and installed it. It looks like the passenger side so I'm a happy camper. I also replaced the Crankshaft Positioning Sensor so hopefully the truck won't stall at a light anymore.
Thread Starter
Newbie
Joined: Aug 2013
Posts: 12
Likes: 0
From: Ky
1999 ML320
