Replacing Rear Bumper Step Pad
Thread Starter
Newbie
Joined: Oct 2015
Posts: 6
Likes: 0
ml350
Replacing Rear Bumper Step Pad
Anyone done this and what are the steps to remove the old one? It's an '13 ML350 and I have looked at it from under the bumper but cannot see how to release the pop-in clips.
Last edited by kagkemb; Oct 30, 2015 at 08:39 AM.
Senior Member
Joined: Sep 2012
Posts: 323
Likes: 31
From: Ottawa ON Canada
2015 ML350 Bluetec
Taken from my DIY Curt Trailer Hitch Install...
" Wire was run/hidden under rear chrome trunkplate… easily removed by a center Torz screw located under spare tire compartment door. Once screw is removed, carefully pry upwards, and plate will release from spring clip inserts!"
Torz screw is facing rearwards, towards gate latch, just under spare tire compartment door..... I used an upholstery/trim plastic pry bar... no marks!
" Wire was run/hidden under rear chrome trunkplate… easily removed by a center Torz screw located under spare tire compartment door. Once screw is removed, carefully pry upwards, and plate will release from spring clip inserts!"
Torz screw is facing rearwards, towards gate latch, just under spare tire compartment door..... I used an upholstery/trim plastic pry bar... no marks!
Junior Member
Joined: Jul 2015
Posts: 41
Likes: 12
From: Atlanta, Georgia
Current: 2025 GLS 580; Sold: 2020 X5 M50i || 2014 ML350
