W166 Rear Fog switch from left to right with Vediamo
Thread Starter
Member
Joined: May 2008
Posts: 223
Likes: 35
merdeces s320
W166 Rear Fog switch from left to right with Vediamo
I'm trying to enable the right foglight on a W166 ML350 2012 that I shipped from the USA to the UK.
WIS shows the wire on pin3 switching from left inner tail light to right inner tail light for RH fog light.
I already switched the wire but light still does not come on, I think its disabled in the SAM
I tried switching around the following values in the CBC file in vediamo, still no fog light.
Fragments Values
PLSM_HW_NSL_li freigegeben
PLSM_HW_NSL_re nicht freigegeben
I've attached my sam coding file, would love any pointers to solve this.
Am happy to pay if someone can do it via teamviewer.
WIS shows the wire on pin3 switching from left inner tail light to right inner tail light for RH fog light.
I already switched the wire but light still does not come on, I think its disabled in the SAM
I tried switching around the following values in the CBC file in vediamo, still no fog light.
Fragments Values
PLSM_HW_NSL_li freigegeben
PLSM_HW_NSL_re nicht freigegeben
I've attached my sam coding file, would love any pointers to solve this.
Am happy to pay if someone can do it via teamviewer.
Member
Joined: Aug 2007
Posts: 228
Likes: 39
From: Peoria, IL
2007 C350 2015 ML400 1968 Ford Mustang
Have you changed the right inner tail light to a LHD version? I drive a 2015 and the right inner tail light has the reflector, but no LEDs. Without changing the hardware, no wiring or coding change will illuminate the right foglight. Shine a flashlight up in the foglight and compare left to right, I am betting there is a difference.
Thread Starter
Member
Joined: May 2008
Posts: 223
Likes: 35
merdeces s320
Thanks JRSmith, you hit the nail on the head.
I was so engrossed making sure the wiring was correct, checking voltage etc, I did not think to check the light itself
The right light is indeed missing the required LED's. Will order a UK replacement
I was so engrossed making sure the wiring was correct, checking voltage etc, I did not think to check the light itself
The right light is indeed missing the required LED's. Will order a UK replacement
