M112's MAF Signals?
![Turbo]['s Avatar](data:image/svg+xml;utf8,<svg xmlns='http://www.w3.org/2000/svg' viewBox='0 0 50 50'><circle class='avatar-circle-default' fill='%23b53a52' cx='25px' cy='25px' r='20px'></circle><text class='avatar-text-default' x='49%' y='53%' fill='white' text-anchor='middle' alignment-baseline='middle'>T</text></svg>)
Member
Joined: Mar 2003
Posts: 79
Likes: 0
From: Lancaster , PA
'03 C230K
Its a hot film type sensor, there is a small heated wire in the middle of the air flow which is cooled off more as more air flows in. The ME figures in the amount of current it takes to keep the wire at a pre set temp, and gets a reading from that. Its not one you want to mess with cause the computer will throw on the F-U light.
2003 C230k magma, c5 , c7, 6 spd
2003 C230k magma, c5 , c7, 6 spd
Newbie
Joined: May 2003
Posts: 12
Likes: 0
mass air sensor
yes, this is partley correct. the sensor keeps the wire 160 degrees celcius above ambient temerature for a base, the output to the ME is linear 1.2 - 1.8 volts at idle, voltage increases as airflow increases up to 5 volts.
test using oscilliscope is suggested, due to multimeter internal impedance.
test using oscilliscope is suggested, due to multimeter internal impedance.
