How do I access fog light for E-class?
#1
Super Member
Thread Starter
How do I access fog light for E-class?
My E55 left fog light broke after I ran over some kind of rodent. I just bought a new one but how do I get a complete access to the fog light housing? I could open a small panel door but the space is not big enough to take the light out. Do I have to take off part of the front bumper to do this? Any help or suggestions will be greatly appreciated.
John
John
#2
MBWorld Fanatic!
Join Date: Nov 2001
Location: Jacksonville Florida
Posts: 3,858
Likes: 0
Received 3 Likes
on
3 Posts
209/W210 Estate /W211 modded by MBENZNL
You Can Remove The Forward Splash panel It Will Give You all the room you will want!
The Little door is good for Bulb Changes...
BTW You May Want to look into the Clearbra Covers....
www.clearbra.com.....You WONT replace another lens!
The Little door is good for Bulb Changes...
BTW You May Want to look into the Clearbra Covers....
www.clearbra.com.....You WONT replace another lens!
Last edited by MARK CUMMINS; 07-09-2003 at 05:17 PM.
#3
Super Member
Thread Starter
Thanks Mark,
It took me about 1 hour for the job. I took off the forward splash panel and another panel behind it, and replaced the complete fog light. This job save me 1.5 hour of labor dealer was going to charge me plus $150 for the light. Thanks again
John
It took me about 1 hour for the job. I took off the forward splash panel and another panel behind it, and replaced the complete fog light. This job save me 1.5 hour of labor dealer was going to charge me plus $150 for the light. Thanks again
John