P1747, P0702, P0500 code 97 Mercedes E320 4 matic wagon
Thread Starter
Newbie
Joined: Feb 2016
Posts: 2
Likes: 0
Mercedes E320 4 matic Wagon
P1747, P0702, P0500 code 97 Mercedes E320 4 matic wagon
I really need some help here. I've found nothing on the forum identical to my problem. 2 months ago my cars instrument panel went wack (water temp and rpm needle bouncing up and down, speedometer stays on "0"). Steps I took:
1. MB dealer said I needed new transmission
2. Read MB forum instead
3. Replaced conductor plate, 13 pin connector, cleaned wire harness and TCM completely after fluid leaked into TCM
4. Had codes cleared, 5 minutes later ABS, ESP, BAS, and brake light appear and instrument panel goes wack again showing P0702, P1747, P0500.
5. Guy says my instrument panel is faulty and may need a new one
Questions are:
Is it my TCM that's bad causing the instrument panel? Or did the fluid leak into the TCM affect something else. Or is just the instrument panel bad? Please help, I don't know where to go from here.
1. MB dealer said I needed new transmission
2. Read MB forum instead
3. Replaced conductor plate, 13 pin connector, cleaned wire harness and TCM completely after fluid leaked into TCM
4. Had codes cleared, 5 minutes later ABS, ESP, BAS, and brake light appear and instrument panel goes wack again showing P0702, P1747, P0500.
5. Guy says my instrument panel is faulty and may need a new one
Questions are:
Is it my TCM that's bad causing the instrument panel? Or did the fluid leak into the TCM affect something else. Or is just the instrument panel bad? Please help, I don't know where to go from here.
Thread Starter
Newbie
Joined: Feb 2016
Posts: 2
Likes: 0
Mercedes E320 4 matic Wagon
Someone did not do the job correctly,P0702 indicates that there is a fault in the TCU--read the TCU to determine the fault----P0500 advises that there was a CAN failure---no message sent from L front wheel speed sensor--dab sensor of faulty ESP module--test with DAS Xentry!!
Last edited by BeeperJ143; Feb 5, 2016 at 02:06 PM.
