iCarsoft MB V2.0 scanner
Thread Starter
Newbie
Joined: Jun 2020
Posts: 9
Likes: 2
From: Sydney Australia
CLK200K A209
iCarsoft MB V2.0 scanner
I have purchased an iCarsoft MB V2.0 scanner and when I connect it to the car, my 2005 CLK200K convertible, A209 model, it only reads the first two modules, ECM and TCM!
I bought the scanner to assist in reading faults with the Parktronic system and it will. not read any of the module except the first two so trying to determine what the fault is and looking for help.
Does anyone with a similar car model/year have this scanner and can they read all the 24 modules?
I bought the scanner to assist in reading faults with the Parktronic system and it will. not read any of the module except the first two so trying to determine what the fault is and looking for help.
Does anyone with a similar car model/year have this scanner and can they read all the 24 modules?
MBWorld Fanatic!
Joined: Mar 2014
Posts: 6,397
Likes: 695
From: Northwest Illinois
2014 E350 also restored: 1969 Camaro convertible SS 1957 Chevy Belair 2dr hardtop
Welcome I believe you have to have a special scanner but not sure. someone here should know be patient someone will have the answer
Thread Starter
Newbie
Joined: Jun 2020
Posts: 9
Likes: 2
From: Sydney Australia
CLK200K A209
I have today scanned the car with another scanner and same issue, can only read engine and transmission modules and came up with this error, P202B-008, CAN data from control module EIS, CAN signal interruption Drive authorization.
so the issue is with the car and not the scanner. Everything is working ok so I believe that the CAN is communicating ok, had a problem with the Parking sensors not working and found loom unplugged in boot, reconnected it and they are all working fine. I have also had an error code P2029-02 which I understand could be associated with a faulty air temperature sensor.
so the issue is with the car and not the scanner. Everything is working ok so I believe that the CAN is communicating ok, had a problem with the Parking sensors not working and found loom unplugged in boot, reconnected it and they are all working fine. I have also had an error code P2029-02 which I understand could be associated with a faulty air temperature sensor.
