Help! New to forums and vacuum hose problems
Thread Starter
Newbie
Joined: Nov 2016
Posts: 1
Likes: 0
From: Arizona
1997 Mercedes S320
Help! New to forums and vacuum hose problems
Good afternoon everyone,
Well after many months decided to purchase a 97 Mercedes S320 Black on Black. Loving the car and even started a youtube channel documenting this car and my audi tt. The link is below if you want to follow along my journey of fixing this car up. Anyway I am trying to pass emissions and the dreaded check engine light came on. Car runs pretty good but have had trouble starting it (usually need to wait 5-10 seconds for it to start with the key in ACC) and the gas gauge isn't functioning. Two fault codes popped up: P0105 and P0460. Upon looking around the engine bay I see I have vacuum hoses that weren't connected and broken. So I went out and bought new hoses, however, I don't know where they go because they were not connected. The hoses in question are between the air check over valve, map sensor, and the two connectors underneath the intake manifold. I took photos. Any help you guys can provided/photos would be incredibly helpful. I hope to contribute some good content to the forums. Thanks.
YouTube Link:
https://www.youtube.com/channel/UCQu...81U2cExueNQnZQ
Well after many months decided to purchase a 97 Mercedes S320 Black on Black. Loving the car and even started a youtube channel documenting this car and my audi tt. The link is below if you want to follow along my journey of fixing this car up. Anyway I am trying to pass emissions and the dreaded check engine light came on. Car runs pretty good but have had trouble starting it (usually need to wait 5-10 seconds for it to start with the key in ACC) and the gas gauge isn't functioning. Two fault codes popped up: P0105 and P0460. Upon looking around the engine bay I see I have vacuum hoses that weren't connected and broken. So I went out and bought new hoses, however, I don't know where they go because they were not connected. The hoses in question are between the air check over valve, map sensor, and the two connectors underneath the intake manifold. I took photos. Any help you guys can provided/photos would be incredibly helpful. I hope to contribute some good content to the forums. Thanks.
YouTube Link:
https://www.youtube.com/channel/UCQu...81U2cExueNQnZQ
Last edited by carfun; Nov 27, 2016 at 06:54 PM. Reason: Adding picture
