w220 front lights and install
#1
Member
Thread Starter
Join Date: Jan 2004
Location: Sydney
Posts: 201
Likes: 0
Received 0 Likes
on
0 Posts
w203
w220 front lights and install
does anyone have any links to installing a new set of headlights on a w220, do i need to take the front bar off.....what should i look out for..
thanks
Ross
thanks
Ross
#5
Senior Member
Join Date: Sep 2005
Location: N. Cali
Posts: 310
Likes: 0
Received 0 Likes
on
0 Posts
2003 CL55 stage 4 Renntech and 2006 CLS55 AMG
No I didnt have to take off the bumper when I did mine but it does take a little love... It jams in there pretty good but if you are careful you can do it. If I remember correctly one side was easier than the other.
#7
Senior Member
![](https://mbworld.org/forums/images/ranks/veteran_marine_corp.png)
it doesnt take long at all. about 3 bolts on each side. i cant remember because it has been a few months since i did it. no need to pull the bumper. there is a bolt that attaches to the bumper on the top side that will need to be removed so to make install a bit easier. by removing the bolt, you can slip the lights in. the bolt is located on the left bottom of the light if you are working on the right headlight as you are looking at it from the front. dont forget to put a little lube or some sort of lubricant on the ball joint so you can more easily lip it into its socket.
angel
angel
Trending Topics
#8
MBWorld Fanatic!
Join Date: May 2006
Location: NYC/FT Lauderdale
Posts: 1,978
Likes: 0
Received 1 Like
on
1 Post
W220 M113K
changing lights
yea i had to remove the bolt on the bumper by the fog light part of the light to get mine and get new screws stock where too short to fit but now its all clean!
Last edited by 02S430; 05-11-2006 at 10:45 PM.
#15
MBWorld Fanatic!
Join Date: Jul 2005
Location: OC
Posts: 2,319
Likes: 0
Received 1 Like
on
1 Post
AMG E55, Stage 1, Strait Pipe from Primary Cats
tk is right, you do "not" have to take off the bumper, you "do" have to take out the 2 bumper bolts that are under the hood grille area. you will need to bend the back the bumper a little bit to get them out.. It was easier getting them out then in, for me anyways, be careful