Ball Joint Separator
#1
Senior Member
Thread Starter
Join Date: Feb 2009
Location: Texas
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
2000 Mercedes Benz S500 Designo
Ball Joint Separator
I found this on eBay, for doing the ball joint replacement on my 2000 S500 up front, but I'm not sure if its the right size. I already purchased the installer/remover which specifically states W220. However this tool just says Mercedes Benz 20mm, and the seller had no clue. Any advise? Thanks!
http://cgi.ebay.com/ebaymotors/Heavy...motiveQ5fTools
http://cgi.ebay.com/ebaymotors/Heavy...motiveQ5fTools
#2
MBWorld Fanatic!
Join Date: Jan 2007
Location: Sydney, Australia
Posts: 1,152
Likes: 0
Received 29 Likes
on
23 Posts
190D 2.5 (x2), 190E 2.6, W202 C240,W202 C43 (C55), W210 E55, W212 E250CDI
The only tools you have to have to replace the lower ball joints on a W220 is a big hammer, ball joint fork and a big hydraulic press. Remove the entire stub axle and press it out. Unless you are doing alot of ball joints (workshop) it's not worth the money to buy the tool. BTW, that tool is only for separating the ball joints, not for replacing.
#3
Senior Member
Thread Starter
Join Date: Feb 2009
Location: Texas
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
2000 Mercedes Benz S500 Designo
I already have the tool to install/remove. The separator tool allows to separate out the ball joint easy while still in the car as I am not planning to remove the stub axle. Thanks