Add 1.0 Litre of OIL visit workshop!
Parked the car for a short while, went to start it again & it started but shuddered, I quickly knocked it off, was a bit concerned so tried again, same thing, yikes, so I went to add the OIL, engine was cooking so I left it til the next morning as I was in the hotel car park.
Added the OIL the next morning & car started perfectly. Drove 50 miles & added another 1IL, now it says OIL level OK. Completed the 200Mile trip home no prob & no errors.
Anyway, word of warning when it says gimme some OIL it really means it, assuming that was problem. I'll be carrying 1Li of Mobile 1 0w40 in the boot!
/me braces himself for talk of coil packs & so on
Many of us 2003+ S600 owners have had a faulty engine oil level sensor. The oil pan must be removed to replace the part, but that fixed the problems for me and others.
Will look into that sensor, it does seems to saying OK now, I'm going out to check now too!
Edit: Says I have 8.5QTS of oil, which is about 8 litres so that sounds about right, my message came up about 1.0 when I actually needed 2.0.
Do ya think I should replace that sensor given that it does seem to be (well at least the warning) a little off?
Last edited by sector; Dec 25, 2012 at 02:38 PM. Reason: update after oil check
Probably keep a close eye on the situation. 0w40 isn't cheap, and 600 miles per liter sounds horrible. Over the 12k mile oil change, that's 20liters of oil!!!!!!! My car doesn't even consume 1/2 liter over the interval.
Op didn't say his car is consuming a liter every 600 miles, just that its been reported by others
I'd just monitor the situation and see how much yours is actually consuming before replacing any sensors







