Enable key dependent memory
Thread Starter
Newbie
Joined: Jul 2018
Posts: 2
Likes: 2
W220 S350 2005 EU
Enable key dependent memory
Hi!
I've read (I think even in the manual) that it is possible to change settings on the keys/car so they are registered independently, and therefore allowing you to have up to 12 configurations in total with the 4 keys.
So I know all four keys work as they should (keyless) but I can't seem to get the car to recognize them independently.
I was hoping I could achieve what I had on my old Cadillac STS where everything would adjust to the current key in use. I know Mercedes should support that on memory and climate control.
Any idea how to activate? I believe it was some key operation thingy, click x amounts of times while in pos 2 etc, but I could be wrong.
I've read (I think even in the manual) that it is possible to change settings on the keys/car so they are registered independently, and therefore allowing you to have up to 12 configurations in total with the 4 keys.
So I know all four keys work as they should (keyless) but I can't seem to get the car to recognize them independently.
I was hoping I could achieve what I had on my old Cadillac STS where everything would adjust to the current key in use. I know Mercedes should support that on memory and climate control.
Any idea how to activate? I believe it was some key operation thingy, click x amounts of times while in pos 2 etc, but I could be wrong.
Newbie
Joined: Jun 2020
Posts: 8
Likes: 1
W220
Hi DIYglenn
I am sure that I have read somewhere that Mercedes removed this function some years ago for safety reasons. However, I do believe that it is possible to reactivate it using xentry. I have seen it in the Xentry Simulator program and hope to try it out when I get a C4 Connect unit.
I will watch your post with interest as I want to add this function also.
All the best - tyl3r
I am sure that I have read somewhere that Mercedes removed this function some years ago for safety reasons. However, I do believe that it is possible to reactivate it using xentry. I have seen it in the Xentry Simulator program and hope to try it out when I get a C4 Connect unit.
I will watch your post with interest as I want to add this function also.
All the best - tyl3r
Last edited by tyl3r; Nov 12, 2020 at 03:19 PM.
