License plate frames yes/no (and front plate)
#1
Thread Starter
Super Member
Joined: Dec 2004
Posts: 595
Likes: 67
From: Raleigh, NC
2020 S560 4Matic
License plate frames yes/no (and front plate)
I switched from a standard to a personalized plate from NC. Holes on the new plate didn’t line up with dealer frame so I tossed it. Someone on Reddit suggested a silicone frame to prevent scratches etc. Wondering who uses a license plate frame or who goes without? I kind of like the clean look without one.
Also has anyone found really short screws for the front? The ones I got from Amazon seem just a little too long.
Also has anyone found really short screws for the front? The ones I got from Amazon seem just a little too long.
#2
Have license plates front & rear. California DMV requirement. Don’t use license frames on either.
Last edited by Sactownmb; 10-11-2022 at 12:28 PM. Reason: Incorrect info.
#3
Thread Starter
Super Member
Joined: Dec 2004
Posts: 595
Likes: 67
From: Raleigh, NC
2020 S560 4Matic
My car is from DC. Diplomat car, supposedly. Has a plate holder on front but NC doesn’t require front. And screws seem just a bit too long. Back seems fine without frame. I have these silver caps for the screws but decided not to use them. Screws only highlights the personalized plate.
The following 2 users liked this post by cfmistry:
as.thompson (10-12-2022),
Robb92914 (10-11-2022)
#5
Thread Starter
Super Member
Joined: Dec 2004
Posts: 595
Likes: 67
From: Raleigh, NC
2020 S560 4Matic
#6