When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
It's installed, but needed to cut the center bearing carrier out. and notch the sheet metal right under the rear seat. Ecu was send out couple of time for tune due to too much air entering runs lean. Also got custom stright pipe exhaust. Love my flat bottom steering wheel.
Nice, how long did it take them to make the CF Driveshaft. How long have you been running with it on? Some say the lifetime of CF Driveshafts are very short.
I had it for two years now, did couple of hard drive with it, so far so good. I didn't really go down and inspect yet so have no idea how it's doing now.
I race it at mission raceway and ridge motorsport park. I will look for video , did not track this car for more than 2 years. I use an Audi A3 3.2 for track recent years.
Motor is 320 with cams, Kleemann header and full stright pipe, Ecu by eurocharged, port and polish head, injector, throttle body... Almost everything you can think so on a NA engine. Not sure what hp it makes but I have no problem keeping up with the groups.
looks great as always, Tery, seeing these makes me miss my car even more. I was able to get the car down to 2923 with the 55 motor and trans without driver. you can do it.
Mercedes SLR McLaren 722 S Is Extremely Rare Example Modified by McLaren
Slideshow: A one-of-one U.S.-spec Mercedes-Benz SLR McLaren Roadster became even rarer after a factory-backed transformation at McLaren's headquarters.
