1997 E320 W210/ 722.6 Trans Wiring Harness
#1
Junior Member
Thread Starter
1997 E320 W210/ 722.6 Trans Wiring Harness
Hello All,
I recently had my 1997 E320 go into limp mode. I have found that the wiring harness from the TCU to the tranny does not have any current going through the wires. All 16 of them.
I want to change the harness but am unsure how to go about it. Any suggestions?
Max
I recently had my 1997 E320 go into limp mode. I have found that the wiring harness from the TCU to the tranny does not have any current going through the wires. All 16 of them.
I want to change the harness but am unsure how to go about it. Any suggestions?
Max
#2
MBWorld Fanatic!
Hello All,
I recently had my 1997 E320 go into limp mode. I have found that the wiring harness from the TCU to the tranny does not have any current going through the wires. All 16 of them.
I want to change the harness but am unsure how to go about it. Any suggestions?
Max
I recently had my 1997 E320 go into limp mode. I have found that the wiring harness from the TCU to the tranny does not have any current going through the wires. All 16 of them.
I want to change the harness but am unsure how to go about it. Any suggestions?
Max
What codes were scanned?
The following users liked this post:
max2015 (03-26-2019)
#3
MBWorld Fanatic!
Please see stickies in W210 forum at Benzworld - replace tranny adapter connector (genuine MB or MOPAR only $14) - and pull and clean Transmission Control Module in engine compartment with 1/2 can of MAF cleaner..
#4
Junior Member
Thread Starter
The oil that leaked into the original TCU was very little but I did get another that was completely dry and in good shape.
I didn't know you could change the plug..Does it just unscrew apart?
I didn't know you could change the plug..Does it just unscrew apart?
#6
MBWorld Fanatic!
Trending Topics
#9
MBWorld Fanatic!
Last edited by khomer2; 03-26-2019 at 04:22 PM.
#10
MBWorld Fanatic!