georgiuzunov

Howdy all!

I was just scanning my 2011 E Class E350.

I got the following errors:

Can communication with the component 'B29/3 (Right front bumper Distronic (DTR) SENSOR)' is faulty
Can communication with the component 'B29/6 (Left rear bumper Distronic (DTR) SENSOR)' is faulty

I recently purchased the vehicle and it had a completely flat battery. Upon installing a new battery it started fine and I drove along.
I don't have any errors on my dash or anything, but upon scanning the vehicle with my Autel Maxisys MS906BT I got the errors above and they're STORED.

If I try to delete them, they'll come back again.
Distronic works just fine.

This is my first MB, but I would expect those to trigger some sort of error on dash?

Should I be worried about these?



Here's my VIN if that helps WDDHF5GB2BA470460

CaliBenzDriver

These transient faults are caused by poor connections over long CAN lines. This issue comes straight from factory.

You can disregard them until they become "current".