SL/R107: Wiring Issue With Idle Control Module
Thread Starter
Newbie
Joined: Sep 2020
Posts: 1
Likes: 0
From: Washington DC
R107 380SL
Wiring Issue With Idle Control Module
I need to replace the ICU on my '85 380SL. When I removed the wiring connector block all the wires fell out. I downloaded the correct wiring diagram and put the wires back in the block.
But.
There is one wire and connector left over which is not shown on any wiring diagram, it is Brown with a Red stripe. Any ideas? Should I ignore it? Obviously if the wires hadn't come out of the connector it would be a plug and play issue but it's not the case now. I need some advice.
Thanks
But.
There is one wire and connector left over which is not shown on any wiring diagram, it is Brown with a Red stripe. Any ideas? Should I ignore it? Obviously if the wires hadn't come out of the connector it would be a plug and play issue but it's not the case now. I need some advice.
Thanks
