Header/Exhaust Manifold Torque Specs?
#1
Super Member
Thread Starter
Header/Exhaust Manifold Torque Specs?
I searched for a while but came up empty. Anyone happen to have torque specs handy for the small 10mm copper nuts for a header install?
Regards
Regards
#5
MBWorld Fanatic!
Join Date: Apr 2006
Location: Maryland
Posts: 8,137
Likes: 0
Received 25 Likes
on
17 Posts
Eurocharged 2004 E500, Eurocharged ECU/TCU 2005 SL600, 2010 Caddy SwaggerWagon
I'll tell you exactly what my MB tech told me when I asked the same question:
He said to use the standard MB torque spec of "Guitentight".
I sweat to god, that's what he told me.
He said to use the standard MB torque spec of "Guitentight".
I sweat to god, that's what he told me.
![rolf](https://mbworld.org/forums/images/smilies/rofl.gif)
#6
Senior Member
Guys our header to cylinder nuts ![Smilie](https://mbworld.org/forums/images/smilies/smile.gif)
lol that sounds wrong but aren't they with 6mmx1.0mm thread.
Is head size then 10mm?
in trying to figure out my car is winter stored 45km.away and forgot to check them before I left last weekend
might have a found a local to buy from but gotta check hope u guys can help me
and again a million thx for all the help so far
![Smilie](https://mbworld.org/forums/images/smilies/smile.gif)
lol that sounds wrong but aren't they with 6mmx1.0mm thread.
Is head size then 10mm?
in trying to figure out my car is winter stored 45km.away and forgot to check them before I left last weekend
![Frown](https://mbworld.org/forums/images/smilies/frown.gif)
might have a found a local to buy from but gotta check hope u guys can help me
and again a million thx for all the help so far