Indentifying this specific ball joint. Purchased and installed the rest.
05-24-2011, 10:05 PM
#1
Junior Member
Thread Starter
Indentifying this specific ball joint. Purchased and installed the rest.
Recently replaced the ball joints I purchased from AutoHausAZ thanks to the
great DIY threads and a seperator from Harbor frieght (Aboslute must, fork
seperator not worth the trouble)
Where does this specific ball joint go? I know there are only a few, and should
compare just to those but haven't had a chance to get back under. Thinking
i ordered the wrong part.
Couldn't seem to match it up - its 90 degree joint. I must have been to burnt out
from other ball joint installs. (doing couple friends motor mounts and ball joints)
great DIY threads and a seperator from Harbor frieght (Aboslute must, fork
seperator not worth the trouble)
Where does this specific ball joint go? I know there are only a few, and should
compare just to those but haven't had a chance to get back under. Thinking
i ordered the wrong part.
Couldn't seem to match it up - its 90 degree joint. I must have been to burnt out
from other ball joint installs. (doing couple friends motor mounts and ball joints)
Last edited by fibercus; 05-24-2011 at 10:16 PM.
05-25-2011, 05:39 PM
#2
Junior Member
Thread Starter
Found a parts diagram - looks like I got the wrong ball joint, even though listed as reference to w211
Anyone ever install this before? Maybe its rear
Part # "2103300035MY"
"Ball Joint; Front Lower Left/Right "
Anyone ever install this before? Maybe its rear
Part # "2103300035MY"
"Ball Joint; Front Lower Left/Right "
05-25-2011, 06:17 PM
#3
Senior Member
Join Date: Mar 2007
Location: Nyc
Posts: 350
Likes: 0
Received 1 Like
on
1 Post
SOLD 04 E55 Now 93 w124 3.2 sold W210 E55 sold waiting on W211 E63 p030
A while back when I was changing my front pads, I realized my lower ball joints were shot. I got them for $60 each and my friend from the dealer charged me $150 to put them in. You will need a special tool, like a C clamp type . YouTube it, funny I saw it today. What you pictured there look like a tie rod end.... I could be wrong.
