turbo97se

Hi folks

Yesterday I got a Cruise Control Visit workshop error.

I scanned with DAS and the only faults that come up are associated with the dynamic seats pump valve and OCP (Overhead control panel. I also get one with fuel sender sending implausible signal (may be a stuck sender). But I get no codes associated with Cruise, throttle, ESP etc .. I have searched around and asked a couple of folks. One has said it is a faulty brake pedal switch. I have read other threads that have said steering angle sensor may have something to do with it but do not know how to do the recalibration steps for it to recalibrate the sensor.

Any help would be appreciated!

Thanks!

shardul

iTrader: (1)

run a quick test and clear the fault memory to see if that helps.

ahmad0658

I have had distronic error message for almost a year and could not solve yet !! Cleaned it as per manual and tried to delete error but also didn't work. Before it goes error, it start to detect car only from short distance unlike before where it detect cars from longer distance.

turbo97se

Yes I already ran quick test and tried to clear all the faults, the same fault codes come up but none associated with cruise control that I can figure out. I do not have distronic on my car.

TonyC

Had the same error a few days ago. shut down, restarted a few hours later, it "fixed itself". Wonder wtf it was...