what size flex pipe for Kleeman header install?
#1
Senior Member
Thread Starter
what size flex pipe for Kleeman header install?
guys similar to others on the board, during my Kleeman header install I want to place a stainless flex in between the header and the stock exhaust, can anyone tell me what length and diamtere would work?
Thanks
Thanks
#2
MBWorld Fanatic!
2.75" .... I had to go with 2.5" as it was all they had.
Just chop the main exhaust to fit the setup
Just chop the main exhaust to fit the setup
#5
Senior Member
Thread Starter
i was just going to keep the factory exhaust after the flex
shuold i be looking at the following for this to go on at the reducer to mate to the stock exhaust?
http://www.burnsstainless.com/rd-275-350-16-304-l.aspx
and
http://www.siliconeintakes.com/produ...7e9e0ff969328f
shuold i be looking at the following for this to go on at the reducer to mate to the stock exhaust?
http://www.burnsstainless.com/rd-275-350-16-304-l.aspx
and
http://www.siliconeintakes.com/produ...7e9e0ff969328f
Last edited by saleen01; 02-24-2012 at 01:39 PM.