First time on dyno, what do I need to know?
#1
MBWorld Fanatic!
Thread Starter
Join Date: Jun 2013
Location: 'Merica
Posts: 1,796
Received 148 Likes
on
123 Posts
'04 E55 (Gone but not forgotten), '13 C63 P31 (RIP), another '13 C63 PP
First time on dyno, what do I need to know?
There is a place up the road a bit in Oxford doing a $40 for 3 pulls dyno day today and I was thinking about taking the E up for a baseline run. Anything special i need to know? The place doesn't seem like a euro-shop, should i be concerned? Is taking this car on the dyno just like any other?
#3
MBWorld Fanatic!
Put the car in Dyno mode, make sure the tranny is in m mode, up shift the car to 3rd gear, gently engage the blower clutch in 3rd and then go wot.
Do your pull in 3rd brotha, and follow the steps above. Watch the faces in disbelief lol.
Do your pull in 3rd brotha, and follow the steps above. Watch the faces in disbelief lol.
#4
MBWorld Fanatic!
Join Date: Aug 2007
Location: Jacksonville, FL
Posts: 2,596
Likes: 0
Received 5 Likes
on
5 Posts
05 White Pano E55, Cadillac CTS-V
Here
Just don't forget to take it out of dyno mode when you are done. And something I had trouble with once is I couldn't get it to work and I had my door open. Apparently you need the door closed while doing this or it won't work for you, at least it didn't on my car.
Just don't forget to take it out of dyno mode when you are done. And something I had trouble with once is I couldn't get it to work and I had my door open. Apparently you need the door closed while doing this or it won't work for you, at least it didn't on my car.