2 nights ago my car wouldn't drive anymore. Put it in reverse and it wouldn't go anywhere as I put it into drive it wouldn't go anywhere but just rev up. I recently replaced the tranny not to long ago either. The computer says it's not the electricial control module, but i don't know what else it would be at this point. Please and thank you

 

Maybe a service update is needed.

 

i would start off by looking at the transmission

 

I serviced everything on the car, but they told me to remove that service thing that pops up on my car everytime I turn it on they told me that I would have to take it to the dealer which it was always services at which is far from me.

 

Man I had a scare like this too idk what it could have been I went from S to C in the car and it would only rev up! I than placed in park and back to drive same thing (although I could go in reverse ) finally put it in D and in M mode and BANG back to normal put it back on Sand don't think I'll be touching it anytime soon!!!! Let me know if you find out what it is invade next time I'm not so lucky!!!!!

Thanks

 

Damn iPhone, S not sand.
Also no invade *incase lol

 

If transmission fluid is leaking through the cannon plug connector it will wick its way to the TCU. Also a real possibility that the conductor plate is bad. You need to have a proper scan. Oh, and one other thing; you must use a dielectric transmission fluid type 134. Best product is Fuchs 4134.

 

Sounds like the shifter rod fell off, very common especially if the transmission was removed and the shifter clips were not replaced after re-installing.

 

That leads to the question to the OP "will the car roll in neutral?"

 

This is the first thing that I would check!