Killer Chiller Liquid Line problems
#1
MBWorld Fanatic!
Thread Starter
Killer Chiller Liquid Line problems
I am 99% done with the KC install, but I had problems with the 5/16" liquid line Tee fitting. I lubed the barbs and the inside of the hose with WD-40, but no matter how hard I tried I could not get the OEM hose to slide all the way onto the Tee. I got them past the three barbs, but there is still about 1/2" further down onto the Tee that they could go. The hose supplied with the kit, that goes to the KC unit itself slid on with no problem.
I currently have the two OEM sides of the Tee clamped, right on top of the barbs. I'm taking it to my indy tomorrow for a refrigerant fill. Any suggestions about the Tee? I tried heating it with a torch but that didn't help.
Should it be OK since I have the barbs engaged on both sides? I'm at a loss here...
I currently have the two OEM sides of the Tee clamped, right on top of the barbs. I'm taking it to my indy tomorrow for a refrigerant fill. Any suggestions about the Tee? I tried heating it with a torch but that didn't help.
Should it be OK since I have the barbs engaged on both sides? I'm at a loss here...
#2
Same thing happened to me, just clamped in on the Barb's and it hasn't leaked at all. Is this proper? No. But I could not for the life of me get it on all the way.
youre gonna love the KC by the way!
-travis
youre gonna love the KC by the way!
-travis
The following users liked this post:
rawdvm (04-30-2017)
#3
MBWorld Fanatic!
Thread Starter
Saturday is the West Coast Shootout so this f***ker's getting charged with refrigerant regardless! Hopefully all goes will on the first try because I don't have a lot of time left to work the bugs out.