GEARBOX SHIFT CONTROL FAILED!!
#1
MBWorld Fanatic!
Thread Starter
GEARBOX SHIFT CONTROL FAILED!!
Hey guys,
So my ISM module is gone. I looked at the WIS sheet and it says I need to lower the gearbox and undo the driveshaft and exhaust. Jesus Christ why put something like this in such an awkward position, to make more money from labor I guess.
Has anyone done this, is there any possibility of doing it without all that? The car is gonna be hard to tow to a lift. I put it up and went under, its tight, really tight. I have to do it in place otherwise I would need to disconnect the driveshaft or put wheel trolleys on the back or something to tow it to a lift. What a pain in the ****.
Anyone done this before?
Thanks.
PS. Already scanned and confirmed it's the ISM. I have one already. Needs to be put in and adapted/coded.
So my ISM module is gone. I looked at the WIS sheet and it says I need to lower the gearbox and undo the driveshaft and exhaust. Jesus Christ why put something like this in such an awkward position, to make more money from labor I guess.
Has anyone done this, is there any possibility of doing it without all that? The car is gonna be hard to tow to a lift. I put it up and went under, its tight, really tight. I have to do it in place otherwise I would need to disconnect the driveshaft or put wheel trolleys on the back or something to tow it to a lift. What a pain in the ****.
Anyone done this before?
Thanks.
PS. Already scanned and confirmed it's the ISM. I have one already. Needs to be put in and adapted/coded.