S63 10-spoke wheel
#1
Member
Thread Starter
S63 10-spoke wheel
hello everyone... wondering if someone can shed light on what the offset and fitment for the S63 is vs. the E63. the reason i ask is because i am in love with the S63 10-spoke, and would love to figure out a way to make this work on my S213. they are a great evolution of the 10-spoke on the previous generation, which is one of the nicest oem wheels available in my opinion. i know it's probably not a reality, but hoping that someone could clarify it for me. configurator photoshop magic below...
#2
MBWorld Fanatic!
Join Date: Jul 2013
Location: Toronto, Ont, Canda
Posts: 2,353
Received 668 Likes
on
515 Posts
go fast grocery getter wagon
Front : 20 x 8.5 et 39
> compared to E63S factory setup (20 x 9.5 et 25). -1mm clearance to strut housing . +27mm extended outward
Rear: 20 x 9.5 et 39
> compared to E63S factory setup (20 x 10 et 55). +22mm clearance to strut housing. +10mm extended outward
Therefore, the rear is workable but the front is going to be odd looking due to excess extension of the wheel.
#3
Member
Thread Starter
Front : 20 x 8.5 et 39
> compared to E63S factory setup (20 x 9.5 et 25). -1mm clearance to strut housing . +27mm extended outward
Rear: 20 x 9.5 et 39
> compared to E63S factory setup (20 x 10 et 55). +22mm clearance to strut housing. +10mm extended outward
Therefore, the rear is workable but the front is going to be odd looking due to excess extension of the wheel.
> compared to E63S factory setup (20 x 9.5 et 25). -1mm clearance to strut housing . +27mm extended outward
Rear: 20 x 9.5 et 39
> compared to E63S factory setup (20 x 10 et 55). +22mm clearance to strut housing. +10mm extended outward
Therefore, the rear is workable but the front is going to be odd looking due to excess extension of the wheel.
#4
MBWorld Fanatic!
Join Date: Jul 2013
Location: Toronto, Ont, Canda
Posts: 2,353
Received 668 Likes
on
515 Posts
go fast grocery getter wagon
if you are to buy the same rear wheel and put that to the front, then the result would be:
-14mm closer to the strut and +14mm extended outward. Not sure if this is still workable or not. I don’t believe adding spacer is the answer here