P30 Rotor Swap
#2
MBworld Guru
#3
Super Member
Thread Starter
Hi
Thank you for that...I had read a few posts saying the P30 204's rotors could be swapped for the regular single piece ones, therefore assumed this would be the case here too...?
Thank you for that...I had read a few posts saying the P30 204's rotors could be swapped for the regular single piece ones, therefore assumed this would be the case here too...?
#4
Senior Member
The P30 discs are larger in diameter. What you would need is different brackets or run spacers. I'd say search a little, you can find the article about the guy who had spacers machined to space out the calipers.
The following users liked this post:
ap10046 (02-23-2018)
#6
MBWorld Fanatic!
Join Date: Aug 2006
Location: A.D., U.A.E
Posts: 7,002
Likes: 0
Received 377 Likes
on
342 Posts
00 C200 & 00 C55 & 06 SLK55
I tried W211 E63 2-piece Rotor with E55 caliper & spindle,,
it fit perfectly, just need little bit cut the protective plate edges, for caliper bracket clearance..
-;ZAYED;-
Trending Topics
#8
MBWorld Fanatic!
Join Date: Aug 2006
Location: A.D., U.A.E
Posts: 7,002
Likes: 0
Received 377 Likes
on
342 Posts
00 C200 & 00 C55 & 06 SLK55
No bro., i meant; "W211 E55 or E63" uses the same (360x36) Rotor,,
for that should be no problem to fit E63 2-piece with E55 8-pot caliper..
(390x36) is another thing & need adapter for sure..
-;ZAYED;-
for that should be no problem to fit E63 2-piece with E55 8-pot caliper..
(390x36) is another thing & need adapter for sure..
-;ZAYED;-
The following users liked this post:
ap10046 (02-28-2018)
#10
Super Member
Shimmed stock calipers
I used 17mm shims when upgrading my stock 360 disks to 390's
Machined from a 1 1/4" diameter aluminum rod. Although a 1 1/8" rod woulda been enough
Last edited by Tech-Tune; 03-08-2018 at 08:59 PM.
The following users liked this post:
ap10046 (03-12-2018)
#14
Super Member