Workshop mode problem for rear brake change

Oct 27, 2024 | 12:49 PM

TND4LSU

Thread Starter

Junior Member

Joined: Aug 2022

Posts: 33

Likes: 2

From: Trussville, Alabama

AMG GLC 43

Workshop mode problem for rear brake change

When I get in workshop mode I get a message when I press brake pad change…”conditions not met” try again basically. I’ve tried getting out of vehicle…locking doors and then starting over only to get the same message. Any suggestions?

Oct 27, 2024 | 01:51 PM

W205C43PFL

MBWorld God!

Joined: Dec 2019

Posts: 31,484

Likes: 6,112

Quote:

Originally Posted by TND4LSU

Is the key/keyless button in position 1 or position 2?

Oct 27, 2024 | 01:58 PM

TND4LSU

Thread Starter

Junior Member

Joined: Aug 2022

Posts: 33

Likes: 2

From: Trussville, Alabama

AMG GLC 43

Quote:

Originally Posted by W205C43PFL

Is the key/keyless button in position 1 or position 2?

yried it both ways and only position 1 (1 push of start button) allows me to get into workshop mode.

Oct 27, 2024 | 02:05 PM

W205C43PFL

MBWorld God!

Joined: Dec 2019

Posts: 31,484

Likes: 6,112

Quote:

Originally Posted by TND4LSU

yried it both ways and only position 1 (1 push of start button) allows me to get into workshop mode.

You could try disengaging the parking brake not sure if it was a prerequisite but worth trying.

Reply Subscribe