Mark this thread as Unsold
FS: 19" Forgestar CF-10 Wheels w/ Michelin PSS
04-05-2017, 06:31 AM
#1
Senior Member
Thread Starter
FS: 19" Forgestar CF-10 Wheels w/ Michelin PSS
Forgestar CF-10 wheels finished in Silver. They are 19x8.5F, 19x10R. The offsets measure +40F and +52R. They fit perfectly on the W204/W205 C63, with a nice aggressive stance. No rubbing of any kind. Will likely fit most other W204 or W205s, but contact me and we can verify. The rears have a nice deep concavity to them; the fronts are a bit "flatter".
The wheels are in near-perfect shape: no curb rash, dents or dings. There is one small scrape about 1/2" long on the spoke of one front wheel (see pics).
The tires are Michelin Pilot SuperSports: 235/35R19F and 275/30R19 rear. No plugs or repairs. I had the rear toe alignment set to the factory min to prevent excessive tire wear; these tires have PLENTY of meat left: about 7/32" front and 6/32" rear.
I've put 5k miles on this setup since new. Included are TPMS sensors (purchased new with the wheels 3/31/2016) and the correct conical lug bolts. Cost over $3k for everything new. Will sell for $1900/shipped to anywhere in the contiguous US, or can be picked up in southern NH or northern MA for $1750.
You can just see the scrape on the spoke in the upper left of the picture here.
Close up of scrape. Measures just over 1/2". Call it 5/8".
Minor imperfection in the powdercoat. Came thus way from Forgestar, and am told it's typical.
The wheels are in near-perfect shape: no curb rash, dents or dings. There is one small scrape about 1/2" long on the spoke of one front wheel (see pics).
The tires are Michelin Pilot SuperSports: 235/35R19F and 275/30R19 rear. No plugs or repairs. I had the rear toe alignment set to the factory min to prevent excessive tire wear; these tires have PLENTY of meat left: about 7/32" front and 6/32" rear.
I've put 5k miles on this setup since new. Included are TPMS sensors (purchased new with the wheels 3/31/2016) and the correct conical lug bolts. Cost over $3k for everything new. Will sell for $1900/shipped to anywhere in the contiguous US, or can be picked up in southern NH or northern MA for $1750.
You can just see the scrape on the spoke in the upper left of the picture here.
Close up of scrape. Measures just over 1/2". Call it 5/8".
Minor imperfection in the powdercoat. Came thus way from Forgestar, and am told it's typical.
Last edited by nobbyv; 04-07-2017 at 08:32 AM.
04-06-2017, 06:30 AM
#4
Senior Member
Thread Starter
04-06-2017, 04:22 PM
#5
Senior Member
Thread Starter
I can't edit my day-old original post for some reason. The offsets measure +40F and +52R. It's a nice flush fitment without any excessive "poke".
