Removing front headrests
#1
Junior Member
Thread Starter
Join Date: Dec 2008
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
W203 C200K
Removing front headrests
How do u guys remove the front headrests on a C200K. I've read all 400 pages of the manual n there's nothing in there about removal of front headrests. It only shows the rear headrests which is the usual push on release button at bottom of the chrome legs n just pull it right off. Mine's the manual headrest type without any electronics.
#2
MBWorld Fanatic!
Join Date: Nov 2007
Location: NYC
Posts: 2,078
Likes: 0
Received 4 Likes
on
4 Posts
2012 C300 4Matic
Not too sure with 07 because you have neck-pro. I know in pre 07 vehicles without a motorized head rest you simply recline the seat far enough that you can pull the head rest all the way out.
#3
Junior Member
Thread Starter
Join Date: Dec 2008
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
W203 C200K
#4
Out Of Control!!
Join Date: Nov 2005
Location: OC
Posts: 18,677
Likes: 0
Received 9 Likes
on
9 Posts
a quarter mile at a time
On the 2006+ cars, you have to remove the two torx screws on the bottom of each seat back and remove the seat back. You'll see a metal clip on the end of one of the rods that hold up the headrest. Remove the metal clip, undo the neck-pro wiring and then the headrest will come out.
#5
Senior Member
Join Date: Oct 2008
Location: Las Vegas, NV
Posts: 312
Likes: 0
Received 3 Likes
on
2 Posts
C230 Kompressor Sport Sedan
On the 2006+ cars, you have to remove the two torx screws on the bottom of each seat back and remove the seat back. You'll see a metal clip on the end of one of the rods that hold up the headrest. Remove the metal clip, undo the neck-pro wiring and then the headrest will come out.
the people on this site never cease to amaze!
#7
Junior Member
Thread Starter
Join Date: Dec 2008
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
W203 C200K
Arghhhh I tried reclining the seat all the way back n pulling on the headrests while pressing the release button but it doesnt work. I dont think my headrests have the Neck Pro system as it's not a motorised headrest. It's a fully manual headrest on a seat with motorised seat back n bottom. Any1 got any other ideas??
Trending Topics
#9
On the 2006+ cars, you have to remove the two torx screws on the bottom of each seat back and remove the seat back. You'll see a metal clip on the end of one of the rods that hold up the headrest. Remove the metal clip, undo the neck-pro wiring and then the headrest will come out.
#11
Out Of Control!!
It would help you two to go to the correct forum.
I don't know how different the W204s are, but you're better off to not take any advice from this forum without checking yours first.
I don't know how different the W204s are, but you're better off to not take any advice from this forum without checking yours first.
#13
Out Of Control!!
No problemo. :-)
Really, though - any advice here should be taken with a grain of salt until you can verify that your newer gen c classes are similar in that particular area.
Really, though - any advice here should be taken with a grain of salt until you can verify that your newer gen c classes are similar in that particular area.