ML Comand Question
Thread Starter
Member
Joined: Jan 2004
Posts: 93
Likes: 0
From: Florida
ML Comand Question
I was playing around with Comand and read through some of the other posts, i tried the OK+7+Mute to get into the additional Comand menus. I tried the codes in both MAP mode and in SERV mode and each gave a variety of menus. Has anyone tried altering any of the values?
I was able to play with brightness of the screen; EQ settings (FLAT or Preset) and a few other things. I didn't want to mess with too many of the buttons not knowing what I'm getting into Are there any other features that we can turn on in this mode?
In addition, I pulled some SW/HW versions of the diagnostic menus - these seem fairly old - is an update in order? If so, I would like to make sure the SA can get me the right ones.
SW: KW18/05 v1.000
HW: KW10/05
DC Model: 1648200779
Boot Version: M07/S07
Software Code: 01.70.00
Thanks in advance,
I was able to play with brightness of the screen; EQ settings (FLAT or Preset) and a few other things. I didn't want to mess with too many of the buttons not knowing what I'm getting into Are there any other features that we can turn on in this mode?
In addition, I pulled some SW/HW versions of the diagnostic menus - these seem fairly old - is an update in order? If so, I would like to make sure the SA can get me the right ones.
SW: KW18/05 v1.000
HW: KW10/05
DC Model: 1648200779
Boot Version: M07/S07
Software Code: 01.70.00
Thanks in advance,
