Voice Recongition Source Coding?
05-14-2012, 06:21 PM
#1
Newbie
Thread Starter
Join Date: May 2012
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
N/A
Voice Recongition Source Coding?
Hello,
I am working on a 2002 S430. I have installed the bluetooth and I am now deciding upon whether to install voice recognition. My uncertainties: After installing the voice recognition, do I need to have source coding performed? I have already had source coding performed for the telephone and I have a feeling I do not need source coding for voice recognition but I am not sure. Do I need fuse f64? ( I have read on this site that a member stated that f64 is needed for voice control.) I have a very good feeling that I do not. Additionally, I am following the installation from the phone bulletin for this and appears that I need to: connect the d pin connector from the vehicle harness to the VRM and then complete a daisy chain with the D2B optical cables,mount the bracket holding the VRM into place, and finally installing the PTT lever on the right hand side of the steering wheel column
I am working on a 2002 S430. I have installed the bluetooth and I am now deciding upon whether to install voice recognition. My uncertainties: After installing the voice recognition, do I need to have source coding performed? I have already had source coding performed for the telephone and I have a feeling I do not need source coding for voice recognition but I am not sure. Do I need fuse f64? ( I have read on this site that a member stated that f64 is needed for voice control.) I have a very good feeling that I do not. Additionally, I am following the installation from the phone bulletin for this and appears that I need to: connect the d pin connector from the vehicle harness to the VRM and then complete a daisy chain with the D2B optical cables,mount the bracket holding the VRM into place, and finally installing the PTT lever on the right hand side of the steering wheel column
