InstallUniversity.com - MB DIY Site Refreshed
#1
Senior Member
Thread Starter
InstallUniversity.com - MB DIY Site Refreshed
For those that still visit the site and have not given up hope since we have not added a new install in some time, don't worry. We have just refreshed the site with a new look and will be putting up several installations documents (mainly service events) very soon for the W203.
For those of you that don't know about the site. It is a small attempt at a DIY site when I have a problem with our '02 C240.
Submissions welcome! Just read the rules for submitting them.
You can check out the updated site here. www.installuniversity.com/mb
Regards,
Eric
www.InstallUniversity.com
For those of you that don't know about the site. It is a small attempt at a DIY site when I have a problem with our '02 C240.
Submissions welcome! Just read the rules for submitting them.
You can check out the updated site here. www.installuniversity.com/mb
Regards,
Eric
www.InstallUniversity.com
#3
Newbie
Join Date: Jul 2005
Location: S. San Jose, CA
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
1992 400E
RE: MB DIY Refreshed
I looked at the DIY submissions to your website and I have questions (to the persons who submitted it or anybody) on the "Grab Handle" procedure.
Is it not necessary to disable the SRS when doing this procedure? If yes, where is the "kill switch" for the SRS located?
Thanks is advance.
Mario
Is it not necessary to disable the SRS when doing this procedure? If yes, where is the "kill switch" for the SRS located?
Thanks is advance.
Mario
#4
Newbie
Join Date: Jul 2005
Location: S. San Jose, CA
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
1992 400E
RE: MB DIY Refreshed
Let me re-state my questions on my previous post.
Is it REALLY not necessary to disable the SRS when doing this procedure?
If it is RECOMMENDED to disable the SRS, where is the "disable switch"?
Again, thanks in advance.
Mario
Is it REALLY not necessary to disable the SRS when doing this procedure?
If it is RECOMMENDED to disable the SRS, where is the "disable switch"?
Again, thanks in advance.
Mario
#7
Senior Member
Thread Starter
I got my lift in and it is working so expect an oil change document to come up later this week since I am on vacation and everything.
Last edited by wizkid; 12-26-2006 at 12:53 AM.
Trending Topics
#9
Super Member
Join Date: Dec 2006
Location: Long Island
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
MB
#13
Super Member
Join Date: Dec 2006
Location: Long Island
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
MB