Gynecologist MD

Soo, On my drivers side, the metal wire that holds the bulb in place is a bit loose, creating an "unequal" look to the light when not in fully. I put some electrical tape behind the bulb (where the wire comes out) to hold it firmly in place. Is there a chance it will melt or something?

nobli

are you tlakin about the black vinyl tape used for wires or the shiny aluminum one used for microwave ducts? either one i wouldnt recommend but a picture might bring better solutions out of ppl

Javvy

electrical insulation tape will 100%melt...........flex the wire and get it to set to the right pressure.............or put some pictures up so better suggestions can flow in........

Gynecologist MD

Ill remove it then, and find a different way, thanks for the help, ill see if ill be able to post a pic

the black vinyl kind